There are various metal blade lengths available for reciprocating saws. Use a metal blade attachment on the saw to cut through the bolt. It is a much simpler process if you are using this tool but, again, there is also a bit more risk. The only trouble with this method is that you need to make sure you do not damage the toilet. If you can find a reciprocating saw, then this will be much faster than using a hacksaw. When you have the hacksaw in place you should move the tool in order to cut through the bolt. Stripping the rubber washer may also be possible by using something to remove it. If the rusted bolt is tight against the bottom of the tank, then you may need to also cut through the rubber washer to get to the bolt. This will allow you to push it under the head of the bolt, even if it is mainly worn away. Usually, the blade of a mini hack saw is flexible. This is a manual hand tool that can be used with one hand. Using a mini hack saw is something that you can use to remove rusted tank bolts. This may make it a bit more difficult to remove the bolts. If you have opened the tank of your toilet to find the tops of the bolts swollen and blistered, you may see the head of the bolt turn to dust when you start to use the screwdriver. Removing rusted bolts can be frustrating. If your bolts are rusted, then you are going to need to move on to the following procedures to remove the bolts. This will loosen it.ĭo not turn the bolt with the screwdriver, this will cause problems for you in the future. Then take the wrench over the nut under the tank, and turn it counterclockwise. Use the screwdriver to hold the bolt in place.

The first step to remove your toilet tank bolts, rusted or not, is to take a flat head screwdriver and a wrench. Whether you have wood floors or tile, it is always a good idea to avoid water on the floor.

You should also place a towel on the floor beneath the toilet.

The more water you can avoid, the less mess that will occur.

This is important because when you loosen the bolts, the water may run onto the floor.

Then soak up any residual water with a sponge or towel in the tank,.

You can do so by flushing the tank until it is empty.

After you do this, drain the water from the bowl.

The first step is to turn off the water supply.Before You Do Anything, Drain the Water From the Bowlīefore You Do Anything, Drain the Water From the Bowl.

How to install toilet tank bolts